If you are driving with your high-beam lights on, you must dim them at least 500 ft from any oncoming vehicle, so you don’t blind the oncoming driver. You must use low-beam lights if you are within 200-300 ft of the vehicle you are following.
You must dim your high-beam headlights within: 500 feet of oncoming vehicles. When approaching a vehicle from behind, you are required to dim your bright headlights when you come within: 300 feet from the vehicle.
To prevent your tow vehicle from jerking due to engine lugging when traveling uphill, shift into a lower gear. This also helps improve gas mileage and reduce engine overheating. If you are driving up a long or steep grade, shift to a lower gear and be prepared for your vehicle to slow down significantly.
One method of determining correct distance from the steering wheel is _____. by extending the arm over the steering wheel until the top of the steering wheel is in line with wrist joint.
You must use your headlights between one-half hour after sunset and one-half hour before sunrise. You must also turn on your headlights whenever you use your windshield wipers in bad weather conditions or when there is insufficient light and pedestrians or vehicles cannot be seen clearly at a distance of 1,000 ft.
Low gear is very useful when you encounter a steep hill or extended downgrade. That’s because your brakes work hard when descending, maintaining your speed and fighting gravity as you drive. In regular conditions, this prolonged stress can cause your brakes to overheat – which can even lead to failure!
When descending a steep hill a lower gear gives more engine braking and control, particularly on a bend. … Change down to a lower gear to give yourself more braking power and control.By selecting a lower gear, you should be able to avoid using your brakes too much.
Downhill: Use first gear when driving downhill as a primary source for braking. Engine braking means you don’t need to use the brake pedal as much, which keeps your wheels turning. If the wheels are turning you can steer, important when undertaking a steep downhill run.
When turning corners, use the hand-over-hand or grip and slide method. Do not turn the wheel with only the palm of your hand. Letting the wheel slip through your fingers could be dangerous.
One-hand steering technique is used when backing or operating vehicle controls such as lights, flashers, and wipers, which need you to reach out from the steering wheel. Placing one hand on the steering wheel can help you maintain vehicle balance and prevent steering reversals and potential injury due to a crash.
Blind spots are areas where other vehicles appear to ‘hide’ from a driver’s sight. … One of those ways is by following the Blind Spot and Glare Elimination mirror setting, also known as BGE. This mirror setting — when used correctly — makes it virtually impossible for a vehicle to disappear into a blind spot.
Use your low beams when you come within 500 feet (about one block) of an oncoming vehicle. Also use your low beams when following another vehicle within 300 feet. Slow down when nearing a curve if you are driving the maximum posted speed limit.
When headlights are required, bright lights should be dimmed at least 500 feet before meeting and 300 feet before overtaking another vehicle. When passing another vehicle, you should not cut back into the right lane until you can see the vehicle that you just passed in your rear view mirror.
Headlights are required when visibility is 500 feet or less. Drivers must use their headlights when they turn on the windshield wipers. Headlights are also necessary when driving through fog, smoke, mist or other weather conditions which reduce visibility.
From Longman Dictionary of Contemporary English dim your headlights/lightsAmerican English to lower the angle of the front lights of your car, especially when someone is driving towards you SYN dip British English → dim. Quizzes.
When an emergency vehicle is approaching: Pull over to the edge of the roadway, clear of intersections, and stop. Remain there until the emergency vehicle has passed. Watch for others.
You must dim your high-beam lights when within: 500 feet of an oncoming vehicle.
High beams are used for open country driving when there is no traffic in sight. High beams are used when traveling behind other vehicles. If a car approaches you with its high-beam headlights on, you must __________ to keep yourself from being temporarily blinded. You just studied 40 terms!
Use Lower Gears to Go Downhill
When you start to head back downhill, use your engine and transmission to slow the car down instead of the brakes. Shift to a lower gear before you start heading downhill, as this will help slow down the car without you having to ride the brakes, says the National Park Service.
It simply means that you change to a high gear (4 or 5) or a low gear (1 or 2). The basic rule is that you change up through the gears as the speed of the car increases and down when you need more power from the engine. For example, you would change down when climbing a hill or pulling away at low speed.
Use a low gear to slow your vehicle down. What should you do when driving down a steep grade in a car with a standard transmission? Stop, locate owner/operator, and give name and address. Or, leave a written notice.
Low Gear = Easy = Good for Climbing: The “low” gear on your bike is the smallest chain ring in the front and the largest cog on your cassette (rear gears). In this position, the pedaling will be the easiest and you’ll be able to pedal uphill with the smallest amount of resistance.
Let your vehicle roll slowly until the front tire rests against the curb using it as a block. When headed uphill (or downhill) with no curb, always turn your front wheels to the right so that if your vehicle moves, it will roll off the highway, not into traffic.
This type of steering permits the driver to make steering inputs ranging from just a few degrees to gross adjustments up to a half turn of the wheel, while keeping both hands on the wheel for precision adjustments.
Which steering technique is correct when backing? Steer in the same direction you want the car. After starting the engine, but before shifting into drive you should: Keep your foot on the brake.
the correct method of steering through a turn is
your vehicle must be equipped with a horn that is capable of being heard a distance of ____ feet.
if the foot brake fails, the parking brake may be used to stop the vehicle.
when driving during the daytime in fog rain or smoke you must
dim your lights for oncoming vehicles or when you are within 300 feet of a vehicle
you should signal at least _____ before you turn or change position.
you should dim your high beams to low beams when
it is illegal to pass on the right in texas under any circumstances.