What Is A Kickdown Cable? new for 2022

What Is A Kickdown Cable?

The transmission kick down cable works to shift the transmission to a higher gear automatically when the engine is revved or otherwise accelerated. A kick down cable comes installed standard on any vehicle, but there are also a variety of aftermarket kick down cables that can be purchased as well.

Is a kickdown cable necessary?

In fact, if you don’t mind downshifting manually with the shift lever when passing, there’s really no need for a functional kickdown cable or switch at all. … You must install a true TV cable with the correct throttle-lever pivot geometry and then adjust it properly or you will burn up the trans!

What is the purpose of a kick down cable?

One component that helps both drive systems communicate is the kickdown cable. This device helps the engine relay information on revolutions per minute (RPM) to the automatic transmission and essentially tells it that it’s time to shift gears.

Can I drive without a kickdown cable?

Shouldn’t be a problem. The cable adjusts system pressure, so shift pressure. With the cable fully retracted it will shift lazy/slip a lot, if the cable was pulled fully out it will shift more firmly, less slip.

Can you adjust a kickdown cable?

Turn the steel shoulder of the kickdown cable with combination pliers. Turn the cable counterclockwise, adjusting until the cable is fully extended with a small amount of slack in it. The slack prevents the cable from breaking when the accelerator pedal is forced to the floor.

How do you hook up a kickdown cable?

Where is the kickdown cable?

The kick down cable is mounted to the carburetor, or, in the case of fuel injected vehicles, the throttle body. It runs from the butterfly arm on the carburetor down to the side of the transmission, where it attaches to an arm that allows the transmission to shift gears.

When should you use kickdown?

Kick-down is used when maximum acceleration is needed, such as for overtaking. When the accelerator pedal is pressed all the way to the floor (beyond the position normally regarded as full acceleration) a lower gear is immediately engaged.

Is kick down bad for car?

No, unless the engine speed increases excessively (in an emergency you will accept this for braking). Just about any vehicle will deny kickdown if your road speed is too high “at that time”. It will put stress on your drivetrain, but this should be well within design parameters.

When should you use kick down?

Why would you use kick-down? Explanation: The action of sharply pressing the accelerator to the floor (kick-down) will send a signal to the transmission to select a lower gear. This is useful when wanting to accelerate briskly, such as when overtaking another vehicle.

Does TH350 have kickdown cable?

On the 3-speeds (TH350, TH400, etc.), the “kickdown” is indeed just that. When actuated, the transmission shifts down into 2nd gear. That is all, and as such, is NOT required unless you want that functionality. On the OD transmissions (700R4, 2004R, etc.)

Does a Turbo 350 have a kickdown cable?

On a 350, it’s just a kick down cable, no problems. One an 700R4, it’s a throttle position cable and if it’s not hooked up it will burn up the transmission.

Does a TH400 have a kickdown cable?

Instead of a linkage or cable, the TH400 uses an electrical switch that is most often mounted on the carburetor. … The factory used a switch located on the carburetor or on the throttle linkage under the dash that at WOT supplied voltage to the transmission.

READ:  How Much Is A 2016 Scat Pack Charger?

How tight should the kickdown cable be?

you want the cable to just about tight at full throttle. so yes, there might be slack in it at part throttle.

Does a 4l60e have a TV cable?

The 4L60-E and the 4L80-E electronic controlled transmissions are not equipped with a Throttle Valve (TV) cable assembly. The transmission functions normally controlled by the TV cable are controlled electronically

What is a transmission kickdown solenoid?

The kickback solenoid is located within the transmission of your car. It helps the car to down-shift easier, while at the same time maintaining the desired level of torque as well as speed. In some models, such as the Porsche, this solenoid process may be activated once the vehicle drops below a certain speed.

How do you test a kickdown switch?

The kick down switch at the gas pedal can be tested with a multimeter(set on ohms). The solenoid in the pan can be tested by applying 12 volts to the vertical connection at the transmission and listening for a click emanating from the pan. You need to ground the transmission when you do that.

What is a Ford kickdown on a carburetor?

A: Kickdown is a downshift in an automatic transmission triggered when the driver pushes the car’s accelerator to the floor.

How do you adjust a 727 kickdown cable?

1) Hold or affix the kickdown lever on the trans all the way forward. 2) Install 3/16 bit in bellcrank and kickdown linkage. 3) Remove all play from the rod traveling up from the trans pivot to the bellcrank and snap in place. 4) With throttle closed, remove all freeplay from the rod between the bellcrank and the carb.

What is kickdown switch?

An electrical switch that is used to cause a transmission to downshift from a higher to a lower gear ratio.

How do I turn off kickdown cable?

Step 6: Disconnect the kickdown cable from the transmission hook. With the retaining bolt removed, gently pull up on the kickdown cable to expose the linkage that the cable is connected to. Twist the end of the kickdown cable to disengage it from the linkage.

How does a kickdown switch work?

The Turbo 350 kickdown function is mechanically operated via a cable mounted on the intake manifold near the carburetor. When the throttle linkage reaches a specific point, the cable triggers a mechanical detent valve inside the transmission–allowing it to shift into a lower gear.

What will help you move off on a snowy surface?

Explanation: If you attempt to move off in a low gear, there will be more torque (turning force) at the driven wheels than if you use a higher gear. More torque makes it easier for the tyres to lose grip and so spin the wheels.

What is downshifting in automatic?

Modern automatic transmission are sophisticated pieces of machinery that are made up of several components that work together to shift the vehicle’s gears. … The downshift solenoid controls the transmission shifting from a higher gear to a lower gear, such as when the vehicle is slowing down to a stop.

What is BMW kickdown?

The kick-down switch signals the transmission to downshift or “kick down” to the lowest usable gear (based on road speed) when you mash the throttle pedal to the floor.

Why does my gas pedal click when I floor it?

It’s the kickdown switch, it’s in the owners manual. It’s not even a real button, just a metal indent that clicks when forced. When the throttle is at the point the car down****s into the lowest possible gear for the speed you’re at.

How do you downshift in an automatic car?

What type of exercise is kick down?

Cardio kickboxing

READ:  Where Is My Coolant Tank?

Benefits: Kickboxing is a high-impact exercise that builds strength and endurance.

What will happen to your car when driving up a steep hill?

Explanation: The engine will need more power to pull the vehicle up the hill. When approaching a steep hill you should select a lower gear to help maintain your speed. You should do this without hesitation, so that you don’t lose too much speed before engaging the lower gear.

What lights should you use in a tunnel?

Explanation: Before entering a tunnel you should switch on your dipped headlights, as this will allow you to see and be seen. In many tunnels it is a legal requirement. Don’t wear sunglasses while driving in a tunnel.

ZF4 HP18 gear selector & kickdown cable operation

Related Searches

transmission kickdown cable adjustment
kickdown cable replacement
kickdown cable symptoms
transmission kickdown cable install
universal kickdown cable
th350 kickdown cable install
th350 kickdown cable location
th400 kickdown cable

See more articles in category: FAQ